Social Media


Welcome, Guest
Username Password: Remember me

Broken Reference Sensor
(1 viewing) (1) Guest
  • Page:
  • 1

TOPIC: Broken Reference Sensor

Broken Reference Sensor 10 years, 4 months ago #10778

  • Robbie
  • OFFLINE
  • Junior Racer
  • The dread pirate
  • Posts: 51
I'm doing a clutch swap and I've had a hell of a time getting the reference sensors out and broke one off in the sensor housing. This is preventing me from getting the bellhousing off. Any suggestions? How hard is it to remount the sensor housing correctly? With the way the engine sits right now, marking the underside of it is pretty much impossible. I'm also having trouble getting an allen wrench down to the bolts holding the sensor on.
1987 924S #5 NASA RM

Re: Broken Reference Sensor 10 years, 4 months ago #10784

It is is not that hard to remount the sensor right. It just takes a little time. Gap is about the thickness of a penny.
Joe Paluch
944 Spec #94 Gina Marie Paper Designs
Arizona Regional 944 Spec Director, National Rules Coordinator
2006 Az Champion - 944 Spec Racer Since 2002
  • Page:
  • 1
Moderators: joepaluch, KLR
Banner
Time to create page: 0.07 seconds